Problem with more than one DLNA endpoint

Studio
1

Hi

It appears that all DLNA endpoints are given the same settings. This is a problem if you want to switch between two or more which have different capabilities. As an example, the one I use in my study is attached to a DAC which supports rates up to 384 kbps, while the one in the main system only supports rates up to 96 kbps, If I’ve been using the study system I have to remember to change the rate in the settings otherwise my DAC cannot handle the signal.

Surely there should be separate settings for each?

Best regards

Alan

1 Like
2

I have already pointed it out a few years ago, but to no avail.
It’s a pity because with the new, more expensive version it could have been implemented…
Also - why not assign separate icons to different endpoints?

2 Likes